Votre panier est vide

Shield NFC 13.50Mhz pour Arduino + tags

Shiled NFC RFID bi-directionnel pour expérimenter la communication sans contact, identification, tragage, etc ...

L'antenne n'est pas fragile car elle est gravée sur le circuit-imprimé.

Livré avec plusieurs types de Tag.


NFC(Near Field Communication) is a set of standards for smartphones and similar devices to establish radio communication with each other by touching them together or bringing them into close proximity , it builds upon RFID systems by allowing two-way communication between endpoints. Compared with the Bluetooth, which is also short-range communication technology, NFC operates at slower speeds, but consumes far less power and doesn’t require pairing.

This NFC shield based on the PN532 from NXP, it works on ISM band of 13.56MHz, with the built-in NFC Antenna, the communication range would be about 2cm.You can read and write a 13.56MHz tag with this shield, and communicate with each other or smartphone with the P2P(peer-to-peer) communication.

Tags : NFC Card Tag (MIFARE Classic 13.56MHz/1K S50)

  • 1 KiloByte (8 KiloBit) non-volatile EEPROM storage
  • Built in encryption engine with 48-bit key
  • 4 Byte unique identifier burned into the chip
  • 13.56 MHz frequency



  • 5cm max effective range
  • SPI interface with Arduino
  • Supports P2P communication
  • Support ISO14443 Type A and Type B protocals


  • NFC Shield PCBA x1
  • 13.56MHz Tag(Clear Diamond) x1
  • Autres tags : minimum 6

Wiki & External links

  • Prix :
  • Modèle : E5P003
  • En Stock
  • Fabricant : ELECROW

Share |